Products > Test Equipment

Sniffing the Rigol's internal I2C bus

<< < (413/899) > >>

MrsR:
Hi! Guys,
Well I went back and tried again. same PRIVATE KEY came up.
TRIED:
DSAB    Adv. Trig.
DSAC    Decoders
DSEA    CAN Decoders
DSAS    200MHz     This is all I wanted to add mainly for the 1ns Time.
Nothing worked so I got a bit frustrated and tried DSHH.

Well I have a 300 MHz DSO with my 1ns.
Also got all the triggers. Decoders, my Trial bits turned into Official and still kept 56M memory.
I guess it was the memory that caused the problems, being overwritten most likely allowed the code to work.
Thanks again guys,

Rachael :-+

............................. 

MrsR:
 I have the A version FW as I was trying to get the latest FW. for the DS2000. and RIGOL HEAD OFFICE
lied to me and said that the 1000003 was the latest FW and If I wanted to up date I had to have the A version.

I think the A version will stop the theft of the options that we have already paid for. Well it's theft in their eyes. Not mine though I paid over$350 for the extended memory, that was already in my DSO at the time I thought I would get a board to fit into the DSO and then I got a  fancy printed page that left it to me to make sure I got the memory from RIGOL via email.

I better get back to work or I might have to fire my self 8)

CATCH YOU LATER
Rachael :-+

alank2:
Does anyone know what type of async memory the DS2000 has/uses?  The blackfin manual talks about 4 banks of 1M each at 0x20000000.  They configure the registers for all 4 banks although two are configured the same so I don't know if they use all four banks or not.

MrsR:

--- Quote from: Teneyes on December 20, 2013, 07:50:53 am ---
--- Quote from: MrsR on December 20, 2013, 03:14:26 am ---
DSAS    200MHz     This is all I wanted to add mainly for the 1ns Time.
Nothing worked so I got a bit frustrated and tried DSHH.

--- End quote ---
Hi Rachael (and all)
   Note:  DS2202 --> 200MHz only sets the fastest Timebase limit to 2nSec/Div (NOT 1nSec/div)

--- End quote ---

Thanks Len I forgot  :o

Rachael :-+

DL5TOR:

--- Quote from: alank2 on December 20, 2013, 02:50:54 pm ---Does anyone know what type of async memory the DS2000 has/uses?  The blackfin manual talks about 4 banks of 1M each at 0x20000000.  They configure the registers for all 4 banks although two are configured the same so I don't know if they use all four banks or not.

--- End quote ---

Use all 4 banks and the other banks

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod