| Products > Test Equipment |
| Sniffing the Rigol's internal I2C bus |
| << < (452/899) > >> |
| PA0PBZ:
--- Quote from: marmad on December 30, 2013, 04:11:09 pm --- --- Quote from: PA0PBZ on December 30, 2013, 04:08:03 pm ---I tried option DSBA on my non-A model with the laters firmware, it said "option installed" but I can't find any changes, certainly not the 50 Ohm option. Would there be a key for that since it is build into all A models as a standard? --- End quote --- I think it's unlikely. It's a standard feature on new A-models (and so one of their new selling points vs. non-A models), so it I doubt it would ever be sold as an 'option' specifically for HW v.2 non-A owners - thus no key. But perhaps the FW can be patched to enable it. --- End quote --- I agree, but also wonder what the difference is between the A and non-A models so that the 50 Ohm works on the A but not on the non-A 2.0 hardware. Maybe it is as simple as the model number? |
| marmad:
--- Quote from: PA0PBZ on December 30, 2013, 04:16:44 pm ---I agree, but also wonder what the difference is between the A and non-A models so that the 50 Ohm works on the A but not on the non-A 2.0 hardware. Maybe it is as simple as the model number? --- End quote --- It could be... changing the model number of the DSOs was all was that required to enable the different BW settings on non-A models. OTOH, as zombie28 pointed out, Rigol has changed a few things to 'enhance' security on the A-models - although that might be irrelevant in this case. |
| NikWing:
@zombie28: so what to do ... wait for cybernet to find something? ^^ |
| PA0PBZ:
--- Quote from: marmad on December 30, 2013, 04:19:34 pm ---OTOH, as zombie28 pointed out, Rigol has changed a few things to 'enhance' security on the A-models - although that might be irrelevant in this case. --- End quote --- It would be interesting to see what they did to enhance the security, because both A and non-A run on the same firmware, and my non-A still responds to the 'old' keys. Maybe the 2 things are related and it is based on the model number. |
| staze:
Or serial number. |
| Navigation |
| Message Index |
| Next page |
| Previous page |