Products > Test Equipment
Sniffing the Rigol's internal I2C bus
neslekkim:
--- Quote from: AndersAnd on January 16, 2014, 01:58:21 pm ---
2) Then follow the cybernet's instructions posted here.
--- End quote ---
There the geltool is mentioned again, where do one find that?
marmad:
--- Quote from: Avotronics on January 16, 2014, 02:19:53 pm ---Is the DS405XUpdate only for DS405X models or all DS4000.
I'm not reading the whole thread, I just need to know where to put it on my rigol site.
--- End quote ---
According to cybernet's post, any DS4/MSO4 - changing only the digit of the model number (0x4 = 500mhz) which specifies bandwidth (but no guarantees).
Avotronics:
--- Quote from: marmad on January 16, 2014, 02:22:28 pm ---
--- Quote from: Avotronics on January 16, 2014, 02:19:53 pm ---Is the DS405XUpdate only for DS405X models or all DS4000.
I'm not reading the whole thread, I just need to know where to put it on my rigol site.
--- End quote ---
According to cybernet's post, any DS4/MSO4 - changing only the digit of the model number (0x4 = 500mhz) which specifies bandwidth (but no guarantees).
--- End quote ---
Thanks
Avotronics:
Cybernet's modded firmware can be found here permanently.
Sorry, direct linking isn't available.
http://rigol.avotronics.co.uk/msods4000-series/
AndersAnd:
--- Quote from: marmad on January 16, 2014, 02:11:23 pm ---Has this been confirmed to work on an MSO4000?
--- End quote ---
Can't remember if anyone has tested it on an MSO4000, but I'm pretty sure it does work as DS and MSO models use the same firmware.
cybernet also wrote it works with both DS4000 and MSO4000 and also both 2 and 4 channel models:
--- Quote from: cybernet on November 27, 2013, 07:30:33 pm ---this sets model type 0x4 = 500mhz
(whatever channel#, whatever MSO y/n it leaves that intact)
--- End quote ---
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version