Products > Test Equipment
Sniffing the Rigol's internal I2C bus
<< < (531/899) > >>
bluesmoke:

--- Quote from: thetooth on January 19, 2014, 02:12:08 am ---
As i was about to ask, is it possible to only install the 200Mhz with all the other addons(i am very lazy and hate using that selector knob)? I made the mistake of thinking DSAS was 200Mhz+all options, so now i have installed 200+300+addons options. Would it be fair to say i could remove the 300Mhz option and keep the addons?


--- End quote ---

DSEZ will give you 200MHz, CAN, Triggers, Decoders and Memory upgrade on the latest firmware.
echen1024:
Alright. I won a DS1074Z, and would like to help out here. I have installed the options according to the keygen, but is there anything else regarding the 1000Z that you guys would like help with?
eevblogee:

--- Quote from: chebeba on January 18, 2014, 06:04:09 am ---
--- Quote from: eevblogee on January 18, 2014, 12:07:22 am ---i went through old posts and realized for ds2072a dumps are needed.

--- End quote ---

Not any more. You can flash Zombie's patched firmware, which will upgrade you scope to the latest f/w but make it accept pre-A license codes, which means you use the olds keygens to get a license and all works fine.

Only problem with this approach is you will loose your options if you update to stock firmware later.

But please go ahead and do the dumps anyway, to allow more progress. I will as soon as my JTAG arrives.

--- End quote ---

One of our forum member took a screenshot after this firmware upgrade which shows hw version different then 2.0 . Is there any possibility this can cause an issue, should i wait for a keygen which works with stock fw or is it a dream.
eurofox:
Hi,

If I order a Rigol 815 TG with the supplied firmware can I use the keygen?

Please don't say "read the complete treat", I did but it is hard to find out if yes/no it is possible.

If someone recently bought it and use the keygen it should be easy to answer.

eurofox
zombie28:

--- Quote from: eevblogee on January 19, 2014, 07:03:36 am ---One of our forum member took a screenshot after this firmware upgrade which shows hw version different then 2.0 . Is there any possibility this can cause an issue, should i wait for a keygen which works with stock fw or is it a dream.

--- End quote ---

AFAIK HW version '2.0' is not Rigol's term, it's just used on this forum to describe new version of DS2k(A) PCB. The newest HW version displayed by DS2kA scopes I've seen so far is 1.0.2.0.2 and it doesn't change after firmware upgrade (take a look at Flipp's screenshots before and after update).
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod