Products > Test Equipment

Sniffing the Rigol's internal I2C bus

<< < (534/899) > >>

ArthurK:
Cheers thanks heaps worked a treat!

eevblogee:

--- Quote from: marmad on January 20, 2014, 01:10:27 am ---
--- Quote from: aadamson on January 20, 2014, 01:04:50 am ---Thats not true.

My DS2D1547 serial number DS2072A scope when it was a 2072A from the factory showed hardware as 2.0... After using your old keygen mod with new firmware, it still shows my serial number correctly *and* the Hardware version still shows 2.0.
--- End quote ---
I'm pretty sure zombie28 is correct. "2.0" is just what you see when you press Utility -> System -> System Info, but it's not the full hardware version number: 1.0.2.0.2 is the actual number. If not, what exactly do you see when you look at the Extended Info (not Standard)? If you don't know how to see it, instructions are here (you will see your full software and FPGA versions as well).

--- End quote ---

My bad, i was not beware of this hidden system info differs then the original.
After doing the hidden menu trick i start to see the info below;
Sw 00.02.00.00.04
Hw 1.0.2.0.2
Spu 03.01.09
Wpu 00.07.01
Ccu 12.29.00
Mcu 02.13

sigxcpu:

--- Quote from: zombie28 on January 19, 2014, 11:08:34 am ---

AFAIK HW version '2.0' is not Rigol's term, it's just used on this forum to describe new version of DS2k(A) PCB. The newest HW version displayed by DS2kA scopes I've seen so far is 1.0.2.0.2 and it doesn't change after firmware upgrade (take a look at Flipp's screenshots before and after update).

--- End quote ---

It is Rigol's term actually. The normal info screen shows "2.0". The Menu7-6-7 trick shows "1.0.2.0.2".

Edit: Oops, that's for DS2072, without A.

pascal_sweden:
Has it been confirmed already that the HW design is identical between DS2072A and DS2302A?

I know that it has been confirmed between DS2072 and DS2202, but not for the A series AFAIK, and especially not for the new 300 MHz variant.

zombie28:

--- Quote from: sigxcpu on January 20, 2014, 08:33:16 am ---It is Rigol's term actually. The normal info screen shows "2.0". The Menu7-6-7 trick shows "1.0.2.0.2".

--- End quote ---

Yes, Rigol uses inconsistent version names - let's call them 'marketing HW version' and 'technical HW version'. However, the bottom line is that neither of them changes after patched firmware flashing.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod