Products > Test Equipment
Sniffing the Rigol's internal I2C bus
<< < (543/899) > >>
granz:

--- Quote from: neslekkim on January 24, 2014, 02:27:59 pm ---and that one is fairly fast?
I guess it's better then to buy this, since I dont know how to use my ft2232h card..

--- End quote ---

If I remember right it took about 15-20 minutes to dump 32MB of DRAM.

For some unknown reason I couldn't communicate with it from the blackfin toolchain on 64-bit Linux or 64-bit Windows 7, so just keep that in mind.  It worked fine once I tried it on a fresh install of Lubuntu 32-bit.  I didn't investigate further after getting the memory dump.  I believe another forum member had a similar issue with a different programmer, so I believe it's something in the blackfin version of UrJTAG.  Just keep it in mind if you want to minimize wasted time.
neslekkim:
good to know, all my computers use 64bit os, so I guess I'll try from an virtualmachine then
granz:

--- Quote from: neslekkim on January 24, 2014, 02:52:01 pm ---good to know, all my computers use 64bit os, so I guess I'll try from an virtualmachine then

--- End quote ---

Good thing to try.  If it works out for you, definitely post about your success, because I'm sure that would make it easier for lots of folks.

Posterisan:
Here is my Memory Dump from Rigol DS2072A !

Serial #: DS2D1542.....

https://mega.co.nz/#!IEdgVbiR!7ylPllecGTVCT54WldU8zGFLoa4E1niOeGCFLcnEPfI

took me hours to get the dump - my segger jlink does not work ;-((

Andre
neslekkim:
Which firmware version is people having when taking a dump?, I want to upgrade, but not sure if one should dump before and after?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod