Products > Test Equipment
Sniffing the Rigol's internal I2C bus
<< < (551/899) > >>
nmz787:
This and the subsequent post mention an offset that self-cal doesn't fix:
https://www.eevblog.com/forum/testgear/sniffing-the-rigol's-internal-i2c-bus/msg346806/#msg346806

I plugged the signal generator into the input, and indeed with 0mV offset on generator and 20mV PP, you can easily see the signal isn't centered on 0 (not just in 500uV mode either).

Edit: I've got a DS1104Z
alank2:
nmz787 - use the scpi uninstall command (somebody posted a tool to do this not long ago) and then reboot your scope.  Then reinstall a new key without the 500uv option.
RX_Buffer[Broken];:
Hi All, (noob)

I have been watching the DS2xxxn topic for a few weeks , I have Z's Patched F/W on a what was a 2072A.  "Nice Job Z"
However not wanting to turn up to the party empty handed (linux, Jtag & sharing Dumps are not my redeeming features) So I have been investigating other routes.

I have found a DS2xxx  SCPI command that appears un-documented and may be of interest if still supported in f/w.
Having tried on my own unit I get a buss time out error, maybe patched F/W or maybe that all options are already installed, unsure??
It would be interesting to know what reply you get from a standard unit? or if anyone already knows about this CMD already ?

SYSTem:OPTion:VALid?



MrsR:
Hi! Guys,
I am having problems with my RIGOL 2072 DSO modified to 300MHz.
Is there a way to turn it back into a 70 or even a 200MHz model.
I used the 3owl site.
The fault is that I get  screen messages "Parameter out of Range" when I know it isn't.
I did the same tests with works AGILENT scope no problems.
Also I can't put it into Peak Detect well I can but on using, it jumps to Normal.

Thanks Guys
Rachael :-+
AndersAnd:

--- Quote from: MrsR on January 31, 2014, 11:50:55 pm ---Hi! Guys,
I am having problems with my RIGOL 2072 DSO modified to 300MHz.
Is there a way to turn it back into a 70 or even a 200MHz model.
I used the 3owl site.
The fault is that I get  screen messages "Parameter out of Range" when I know it isn't.
I did the same tests with works AGILENT scope no problems.
Also I can't put it into Peak Detect well I can but on using, it jumps to Normal.

Thanks Guys
Rachael :-+

--- End quote ---
Yes just use the SCPI uninstall command as mentioned several times in this topic.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod