Products > Test Equipment

Sniffing the Rigol's internal I2C bus

<< < (582/899) > >>

neslekkim:

--- Quote from: MatCat on February 10, 2014, 09:00:27 pm ---I just spent about 45 minutes going through this thread to try to find it but cant... I am considering getting the DS1074Z, and I am curious where is the info to actually hack it in this thread? :)   Also where is the best place to buy it over here in the US?

--- End quote ---

rly?

https://www.google.no/#q=code+ds1074z+site:eevblog.com%2Fforum%2Ftestgear%2Fsniffing-the-rigol's-internal-i2c-bus
and go to: http://riglol.3owl.com/

dr.diesel:

--- Quote from: MatCat on February 10, 2014, 09:00:27 pm --- Also where is the best place to buy it over here in the US?

--- End quote ---

http://www.tequipment.net/

With discount code EEVBLOG, gets you 6%.

MatCat:

--- Quote from: seronday on December 13, 2013, 12:11:50 am ---
--- Quote from: seronday on December 12, 2013, 01:36:11 pm ---Anyone who wants to change their new DS1074Z into a DS1104Z use the following Codes:-

DSHA  makes a  DS1104Z with no options enabled .
DSHR  makes a  DS1104Z with all options enabled .

The 3dB bandwidth for the DS1104Z is approx 160Mhz.
The 3dB bandwidth for the DS1074Z is approx 90Mhz.



--- End quote ---

Minor correction to my previous post after some further investigation.

DSHA also enables the 500uV setting and another unknown, (at present), option.

DSEA is the correct code to change to a DS1104Z only. ( no options ). See table below.

 Code      DS1104z    Unknown     500uV setting
DSBA                                               X
DSCA                            X
DSDA                            X                 X
DSEA           X
DSFA           X                                  X
DSGA           X               X
DSHA           X               X                 X

So to change a DS1074Z into a DS1104Z with all options enabled except the 500uV/div (which does not work correctly at present),
the code  will be DSER.

It is possible to revert back to original, by using the SCPI command " :SYSTem:OPTion:UNINSTall " .

As mentioned in my previous post, the measured 3dB down bandwidth after changing to a DS1104Z, is approx 160Mhz.
All the tests were done on a DS1074Z with Ver:00.02.00.SP1.

--- End quote ---
Is this entered in on the screen or done some other way? 

MatCat:

--- Quote from: dr.diesel on February 10, 2014, 09:06:02 pm ---
--- Quote from: MatCat on February 10, 2014, 09:00:27 pm --- Also where is the best place to buy it over here in the US?

--- End quote ---

http://www.tequipment.net/

With discount code EEVBLOG, gets you 6%.

--- End quote ---
Looks like they are sold out ATM...

MatCat:
Also http://riglol.3owl.com/ does not  seem to work for me.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod