Products > Test Equipment
Sniffing the Rigol's internal I2C bus
Tilman:
Hello,
300MHZ dosen´t work for my DS2072A only 200MHZ works, any solution?
Thanks
Teneyes:
--- Quote from: Tilman on April 09, 2014, 03:39:07 pm ---Hello,
300MHZ dosen´t work for my DS2072A only 200MHZ works, any solution?
Thanks
--- End quote ---
Do you mean you can not Install 300Mhz option?
Try uninstall first, then just Install 300MHz
hooverphonique:
--- Quote from: mrflibble on April 09, 2014, 02:05:37 pm ---And whenever you run into a :wtf: situation where you are not sure if a command just did what you expected you can check status + logs messages.
--- End quote ---
and where do I find those? the DS2000 programming guide doesn't list commands for that, as far as I could see (I didn't read it fully, though)..
--- Quote from: Teneyes on April 09, 2014, 03:17:12 pm ---Try this old trick ,
Set the System Time to 2099-12-31 23:59;55 and let the Clock roll over.
Then do a Self-Cal. ( a state that it is in the Factory)
--- End quote ---
Thanks for the suggestion.. unfortunately, it didn't make a difference..
mrflibble:
--- Quote from: hooverphonique on April 09, 2014, 03:49:40 pm ---
--- Quote from: mrflibble on April 09, 2014, 02:05:37 pm ---And whenever you run into a :wtf: situation where you are not sure if a command just did what you expected you can check status + logs messages.
--- End quote ---
and where do I find those? the DS2000 programming guide doesn't list commands for that, as far as I could see (I didn't read it fully, though)..
--- End quote ---
Related SCPI commands :
--- Code: ---*CLS
*STB?
*SRE?
*SRE <val>
:STATUS
:SYSTEM:ERROR?
--- End code ---
Don't have a DS2000. Rigol tends to not document everything, so testing a general SCPI command sometimes gives a useful result, 100% depending on what Rigol decided to implement today.
amr:
Hello
I've just tried these codes with my new DS1074Z:
DSAB - Advanced Triggers
DSAC - Decoders
DSAE - 24M Memory
DSAJ - Recorder
DSEA - 100MHz
All options have been installed successfully, but 100 Mhz bandwidth option (DSEA) is not shown in the "Installed Options" screen. Is it right?
The firmware version is 00.02.03.SP5
Thanks.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version