Products > Test Equipment
Sniffing the Rigol's internal I2C bus
BTO:
I don't know if this is relevant or not,
but, all of my above attempts to enter the key, were done DURING the Trial Period
I have 743 Minutes left to go
i suppose if i don't find a solution in that time
i will repeat everything that i have tried, after the Trial period and advise the forum if it works
further to that, i think i'm just using the incorrect private key, Perhaps.
BTO:
HELLO hooverphonique
Oh OK
I did notice (of course that some of these entries are a little old and date back to the DS1000 Series, and there was a lot to filter through and decide what was not relevant and what was), I had to piece bits and pieces together and figure it all out.
Now.. i don't mind re reading the whole thing over again
but.. are you referring to that thing that CYBERNET put up about Flashing the Custom Firmware so that when you load it onto the scope the DS2072A will show up as a DS2022
is that what your referring to ?
if so, i then need to build a PC and Load Linux onto it (My linux skills are limited, Probably good enough to Use Basic Shell Commands in Linux, but I'm not Linux Expert by any means)
the part that confuses me is when we mention the work "compile"
i sort of understand that you need a compiler to (Put together) or "compile" if you will
a script or program
the issue is i don't know how to compile
if it's just an issue of Somehow Getting a .txt file from my PC or from the scope and editing it, using a text editor ... (no worries), i just need to know what line of code to edit
if it's a matter of convert one numbering system to another piece of code, I'm good with that also
I just need to be pointed in the right direction
i understand the point is not, to hand this to me on a platter,
and in all honesty, i would prefer to learn how this is done
but, at the same time, i would like full access to my scope ASAP
either way, i'm going to go back through the POSTS and read it all again and learn how it was reverse engineered to begin with , Reverse engineering is something that i don't understand fully.
so.. What help can you offer me from this point.
thanks
BTO:
@ hooverphonique
Hey Mate
you had me confused at first
i think i'm on the right track now,
at least that something
thanks for the guidance
I'll keep at it and see where i get to
one problem i have is that most of the download files are no longer at their Download locaitons
anyway, i'll keep at it and when i get a solution i'll post it for other to see.
mark03:
--- Quote from: BTO on April 11, 2014, 06:31:19 pm ---anyway, i'll keep at it and when i get a solution i'll post it for other to see.
--- End quote ---
A tutorial already exists:
http://gotroot.ca/rigol/D2072A%20Unlocking%20Guide.pdf
and you should find all of your missing links there too.
GlassFET:
--- Quote from: mark03 on April 11, 2014, 06:54:51 pm ---A tutorial already exists:
http://gotroot.ca/rigol/D2072A%20Unlocking%20Guide.pdf
and you should find all of your missing links there too.
--- End quote ---
Five of us have used that same guide to upgrade our DS2000A scopes. Worked each time. Just follow the instructions EXACTLY. If you're using a Mac or Linux, borrow a Windows machine to run the prescribed programs. You can always wash your hands and return safely to your Mac or Linux later... ;)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version