Products > Test Equipment
Sniffing the Rigol's internal I2C bus
<< < (643/899) > >>
cybermaus:

--- Quote from: alexwhittemore on April 16, 2014, 07:33:48 am ---
--- Quote from: thn788 on March 27, 2014, 10:05:03 pm ---Hi

After reading in Suffer1981de's post about the DS1000Z firmware 00.02.03.SP5, I e-mailed my scope dealer and immediately received the new firmware. Although "new" is probably relative: seems to have been released on Jan. 26th, already. Haven't yet looked for changes or bug-fixes but noticed that the measurement menu on the left side has gained the 8 new measurements that are documented in the User Guide from Jan 2014, which is online on Rigol's website for quite some time, already.

Here is a link to the firmware:  http://www.filedropper.com/ds1000zupdate-v000203sp5

Have fun. :-)

--- End quote ---

This link seems dead. Does anyone have a working one? Is this update legit?

--- End quote ---

Indeed. Anyone has a mirror for that firmware?
Thanks
alexwhittemore:
Requested an update from rigol of it exists, but I haven't heard back. Also reported a couple existing firmware bugs, haven't heard back there either yet.
Mark_O:
Sadly, this thread no longer has anything to do with its named Subject.  :'(  And hasn't for some time.  It's now the, "Can someone explain to me again (for the 100th time) how to hack the options on my Rigol" thread.  :rant: 

That's too bad, because it used to be quite interesting.  But as a result, I'm no longer following it, and I suspect many others have dropped out as well.   |O

In retrospect, it would have been wise, once the flood of newbies-without-a-clue arrived, to have spawned off a separate discussion for that.  But I suspect no one anticipated how quickly that would take over.  Someone could still do that, but I'm not sure at this point if there's any hope for recovery in this one.  It's likely permanently polluted.  It's serving two completely different audiences, and as a result, does neither well.
Sparky:

--- Quote from: Mark_O on April 21, 2014, 03:33:14 pm ---Sadly, this thread no longer has anything to do with its named Subject.  :'(  And hasn't for some time....
That's too bad, because it used to be quite interesting.  But as a result, I'm no longer following it, and I suspect many others have dropped out as well.   |O

--- End quote ---

How about DP832 v01.09 firmware investigation? There has been some change of keys etc after the v01.09 firmware...
alexwhittemore:

--- Quote from: Mark_O on April 21, 2014, 03:33:14 pm ---In retrospect, it would have been wise, once the flood of newbies-without-a-clue arrived, to have spawned off a separate discussion for that.

--- End quote ---

Newbies without a clue? This thread was off topic as soon as the discussion arose of elliptic curve implementation weakness and the possibility of key generation, and it was already a good 30 pages in at the time. Really, 15 pages before even that with trial keys. Hardly the work of newbies without a clue. Have some perspective and try to be a little less holier-than-thou.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod