| Products > Test Equipment |
| Sniffing the Rigol's internal I2C bus |
| << < (648/899) > >> |
| neslekkim:
--- Quote from: Malama on May 12, 2014, 10:51:51 am ---Is there a specific Key for options removal ? --- End quote --- Last paragraph in first post here: https://www.eevblog.com/forum/testgear/sniffing-the-rigol's-internal-i2c-bus/3105/ |
| Malama:
I did not used any cable and windows SW to send the Keys to the scope. Just written Keys directly in the scope generated from Riglol keygen with corresponding Code DSxx. I search THE code DSxx to generate (via Riglol Keygen) a specific Key to be written in the scope which could be clear partly or all of the options. Thanks,JC |
| Malama:
Hi, Yes of course, I tried to use Ultra Sigma and USB cable connect at the rear of scope. The scope is recognize by W7, not by Ultra Sigma, this is the problem. Nothing in Rigol online devices, perhaps due to that DS2302 does not exist (vs DS2302A that exist) , I don't known ? Impossible to issue SCPI command. |
| Malama:
Hi All, Problem solved ! Just a value to be setup at scope level : in Utility / IO setting / USB Device => Computer instead of Pictbridge. Ultra Sigma recognizes the scope as DS2302 and then Options removed without problem using corresponding SCPI command. Thank you all ! :-+ |
| Zone1:
--- Quote ---5. When you are done enter the Option Code manually in the DS1000z using a single string without using any 'dash' (-) using Rigol's Procedure for activating the Trial Options in the D1000z. As I recall the procedure is available on Rigol's Web Site under DS1000z. --- End quote --- I had some difficulty finding the procedures on Rigol's web site for a DS1074Z can someone help? I could not find that specific model. |
| Navigation |
| Message Index |
| Next page |
| Previous page |