Products > Test Equipment
Sniffing the Rigol's internal I2C bus
swanawood:
@pinkman
Did you try what suggested by Gandalf_Sr at page 236 ?
Thanks
radiogeek97:
folks
i am totally ignorant when it comes to simple SCPI commands. I have looked thru the threads and havent found any good explanation on how to initiate and run simple SCPI commands. If anybody could point me in the right direction ( as far as previous threads ect) I will educate myself as much as possible so as not to be a burdon on all of you that have been soo helpful
thanks in advance
Gandalf_Sr:
--- Quote from: radiogeek97 on September 09, 2014, 04:21:50 pm ---folks
i am totally ignorant when it comes to simple SCPI commands. I have looked thru the threads and havent found any good explanation on how to initiate and run simple SCPI commands. If anybody could point me in the right direction ( as far as previous threads ect) I will educate myself as much as possible so as not to be a burdon on all of you that have been soo helpful
thanks in advance
--- End quote ---
Follow the link in my post at the end of page 236 of this thread (previous page). There's not much reading to do.
flatlander:
I'm about to pull the trigger on a MSO-1074z and was wondering if anyone has tried the SCPI method to dump this scope's memory and then use 'rigup' to get the keys to unlock the optional features on this model.
swanawood:
It would be appriciated if radiogeek97 and pinkman give it a try with the DSA-815 and report back the result.
Personally I havo no Rigol instrument to try with (willing to buy 815TG), so I can't help directly.
Thanks
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version