Products > Test Equipment
Sniffing the Rigol's internal I2C bus
exciler:
Hi!
Just got a DS1054Z yesterday from Batronix (in Germany) for 299 EUR (excl. Tax). Numbers are working ;)
So I think it is very good value for the money, highly recommend it.
Magnum:
--- Quote from: exciler on September 21, 2014, 08:38:31 am ---Hi!
Just got a DS1054Z yesterday from Batronix (in Germany) for 299 EUR (excl. Tax). Numbers are working ;)
So I think it is very good value for the money, highly recommend it.
--- End quote ---
I ordered one from Batronix, too. Which firmware version do you have on yours?
poorchava:
So it's upgradeable to 100MHz?
exciler:
--- Quote from: poorchava on September 21, 2014, 06:56:01 pm ---So it's upgradeable to 100MHz?
--- End quote ---
At least it accepts the code, haven“t tested a 100 MHz signal yet.
--- Quote from: Magnum on September 21, 2014, 03:07:16 pm ---
--- Quote from: exciler on September 21, 2014, 08:38:31 am ---Hi!
Just got a DS1054Z yesterday from Batronix (in Germany) for 299 EUR (excl. Tax). Numbers are working ;)
So I think it is very good value for the money, highly recommend it.
--- End quote ---
I ordered one from Batronix, too. Which firmware version do you have on yours?
--- End quote ---
Need to check that tomorrow, but as the DS1054Z is pretty new, I do not expect any difference.
ibraheem:
Brilliant! I should be receiving mine tomorrow so will post up results.
Based on the past few posts I'm under the impression the code to use is still DSER (i.e. it's still not a good idea to install the 500uV option?)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version