Products > Test Equipment
Sniffing the Rigol's internal I2C bus
<< < (717/899) > >>
cap4096:

--- Quote from: seronday on October 04, 2014, 11:58:17 pm ---If it is using one of the Firmware versions mentioned, then , Yes.

Try it and report back.

--- End quote ---

Well I have to order it before trying :-) I will probably do that on monday.
ted572:
Ultra Power Analyzer software for the DS2000, DS4000, and MSO4000 series O'Scopes: https://www.eevblog.com/forum/testgear/first-impressions-and-review-of-the-rigol-ds2072-ds2000-series-dso/msg525924/#msg525924
AndersAnd:

--- Quote from: Teneyes on October 08, 2014, 05:13:15 pm ---
--- Quote from: ted572 on October 08, 2014, 12:20:46 pm ---Ultra Power Analyzer software for the DS2000, DS4000, and MSO4000 series O'Scopes:

--- End quote ---
Yes the Software is available, and it looks like there may be a Key to enable it with the dso. Has anyone seen any codes in the firmware???

--- End quote ---
The "Power Analysis" option is listed in "DS4000 Option Codes.pdf" uploaded to this topic by seronday just a few days ago: https://www.eevblog.com/forum/testgear/sniffing-the-rigol%27s-internal-i2c-bus/msg523679/#msg523679
Howardlong:

--- Quote from: alank2 on October 03, 2014, 05:37:51 pm ---
--- Quote from: farzadb82 on October 03, 2014, 04:15:42 pm ---I tried the procedure on my MSO1000Z and ended up with a constant beeping noise (as if I'd pressed the button too many times), but no reset. It's possible that I did something incorrectly. I'll give it another shot tonight after work.

--- End quote ---

It is the 5th gray button on the left (not the bottom gray button).  When you press it during power on it will beep a couple of times until the Rigol screen comes up.  Keep pressing it.  You'll know it worked when you see Chinese!

--- End quote ---

I confirm that this works, but you need to start pressing the 5th grey button on the left within a few milliseconds after you switch on.

(To change language from Chinese, press the Utility button -> select Language).
rmd79:
Hello,

Could someone please post a key file (without the serial number is fine) generated with "rigup scan ..." from a memory dump of a DS1000Z series scope?

I've tried searching the forum and with Google but haven't had any luck.

Thanks.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod