Products > Test Equipment

Sniffing the Rigol's internal I2C bus

<< < (717/899) > >>

cap4096:

--- Quote from: seronday on October 04, 2014, 11:58:17 pm ---If it is using one of the Firmware versions mentioned, then , Yes.

Try it and report back.

--- End quote ---

Well I have to order it before trying :-) I will probably do that on monday.

ted572:
Ultra Power Analyzer software for the DS2000, DS4000, and MSO4000 series O'Scopes: https://www.eevblog.com/forum/testgear/first-impressions-and-review-of-the-rigol-ds2072-ds2000-series-dso/msg525924/#msg525924

AndersAnd:

--- Quote from: Teneyes on October 08, 2014, 05:13:15 pm ---
--- Quote from: ted572 on October 08, 2014, 12:20:46 pm ---Ultra Power Analyzer software for the DS2000, DS4000, and MSO4000 series O'Scopes:

--- End quote ---
Yes the Software is available, and it looks like there may be a Key to enable it with the dso. Has anyone seen any codes in the firmware???

--- End quote ---
The "Power Analysis" option is listed in "DS4000 Option Codes.pdf" uploaded to this topic by seronday just a few days ago: https://www.eevblog.com/forum/testgear/sniffing-the-rigol%27s-internal-i2c-bus/msg523679/#msg523679

Howardlong:

--- Quote from: alank2 on October 03, 2014, 05:37:51 pm ---
--- Quote from: farzadb82 on October 03, 2014, 04:15:42 pm ---I tried the procedure on my MSO1000Z and ended up with a constant beeping noise (as if I'd pressed the button too many times), but no reset. It's possible that I did something incorrectly. I'll give it another shot tonight after work.

--- End quote ---

It is the 5th gray button on the left (not the bottom gray button).  When you press it during power on it will beep a couple of times until the Rigol screen comes up.  Keep pressing it.  You'll know it worked when you see Chinese!

--- End quote ---

I confirm that this works, but you need to start pressing the 5th grey button on the left within a few milliseconds after you switch on.

(To change language from Chinese, press the Utility button -> select Language).

rmd79:
Hello,

Could someone please post a key file (without the serial number is fine) generated with "rigup scan ..." from a memory dump of a DS1000Z series scope?

I've tried searching the forum and with Google but haven't had any luck.

Thanks.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod