Products > Test Equipment
Sniffing the Rigol's internal I2C bus
akisnas:
Thanks, I'll Check It, Is It Permanent?
Cheers.
AndersAnd:
--- Quote from: akisnas on October 25, 2014, 07:26:08 pm ---Thanks, I'll Check It, Is It Permanent?
Cheers.
--- End quote ---
Yes as it says: "first character: A = official, S = trial".
Official = permanent.
hammy:
--- Quote from: sptm14a on October 17, 2014, 04:50:09 am ---Here is a list of all 8 option codes for DS/MSO1000Z (firmware 00.04.01.SP2):
CSAR Triggers
CSAB Decoders
CSA3 Memory Depth
CSAJ Recorder
CSRA 500uV Vertical
CSAS ?
CSBA ?
CS3A ?
These are "official" options. "Trial" options start with "V", i.e. VSAR == Triggers trial
Plugging these into current versions of rigup/riglol won't work because Rigol slightly changed license validation/generation algorithm and character translation tables. I updated the algorithm to make it work for me, but but I'd rather not release it untested.
--- End quote ---
Thank you for the info. :clap: :-+
Is the MSO1000z and the DS1000z really using the same firmware?
Cheers
hammy
ted572:
--- Quote from: akisnas on October 25, 2014, 07:26:08 pm ---Thanks, I'll Check It, Is It Permanent?
Cheers.
--- End quote ---
akisnas:
If you have a new DSA815 that you received with Firmware 00.01.09 ( 00.01.09.00.07) then you will NOT be able to install the Options at this time until someone comes up up a revised method for installing the Options. Although if you have an earlier version Firmware (prior to 00.01.09), then the current Riglol Keygen (version 1.03c or 1.03d) will work fine for you.
You may want to go to https://www.eevblog.com/forum/testgear/spectrum-analyzer-rigol-dsa815/msg513125/#msg513125 and read forward to understand this issue in more detail. If you have any questions please feel free to contact me via a PM.
sptm14a:
--- Quote from: hammy on October 26, 2014, 05:16:59 pm ---Thank you for the info. :clap: :-+
Is the MSO1000z and the DS1000z really using the same firmware?
--- End quote ---
I believe that Rigol uses unified firmware for all 1000 series, including 1104. The firmware behavior is defined by configuration resistors on the board.
The real question is whether or not the firmware validates licenses the same way for all 1000 series. If somebody can dump memory from DS1074 or DS1054 with newest firmware, run the dump through rigup and PM me its output (or just share the dump), I can check by generating you a license.
Thanks to all MSO1074 testers -- no need for more testing on MSO, it works :)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version