Products > Test Equipment

Sniffing the Rigol's internal I2C bus

<< < (722/899) > >>

hammy:

--- Quote from: sptm14a on October 27, 2014, 04:58:43 am ---Thanks to all MSO1074 testers -- no need for more testing on MSO, it works :)

--- End quote ---

sounds good!  :clap:
Thank you for the work you put into it!  :-+

This means it is time to make a memory dump and wait for the next riglol version on http://gotroot.ca/rigol/?

hematose:
So now that sptm14a has managed to upgrade the MSO1000Z, how do we get this into Riglol and the like? sptm14a, you said you didn't want to release it without testing. Would you like someone to test it for you? How can we continue your work?

akisnas:

--- Quote from: ted572 on October 27, 2014, 02:27:48 am ---
--- Quote from: akisnas on October 25, 2014, 07:26:08 pm ---Thanks, I'll Check It, Is It Permanent?
Cheers.

--- End quote ---

akisnas:

If you have a new DSA815 that you received with Firmware  00.01.09 ( 00.01.09.00.07) then you will NOT be able to install the Options at this time until someone comes up up a revised method for installing the Options.  Although if you have an earlier version Firmware (prior to 00.01.09), then the current Riglol Keygen (version 1.03c or 1.03d) will work fine for you.
You may want to go to  https://www.eevblog.com/forum/testgear/spectrum-analyzer-rigol-dsa815/msg513125/#msg513125  and read forward to understand this issue in more detail.  If you have any questions please feel free to contact me via a PM.

--- End quote ---
Thank You So Much For Your Reply, It Was Really Informative, I'll Try To Contact With You Via Pm When I'll Go To My Lab At The End Of Next Month.
Thanks All Of You.
Best Regards

0xdeadbeef:
Just out of curiosity: is it expected that it will be possible to create keys for the MSO1000Z without dumping the flash (i.e. through entering the serial number)?
And if dumping is needed: does it require opening the case for a JTAG connection or is it also possible over SCPI like with the DS2000A/MSO2000A ("Bildschirmkopie")?

Howardlong:
I couldn't get the SCPI commands to work on the MSO1000Z, I had to use a JTAG connector.

The process of extracting the dump itself took 15 minutes, once I knew what I was doing. Getting to that stage took an awful lot longer though!

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod