Products > Test Equipment
Sniffing the Rigol's internal I2C bus
<< < (748/899) > >>
msraya:
Oh! I'm sorry Sandra  :palm:

The rate of women/men EEngineering students at my University, here in Spain is very bad indeed.
So I suppose the wrong.

I will try to use the JTAG with my oscilloscope and will update when it succeeds.
Regards
Manuel
Rigby:

--- Quote from: smgvbest on December 16, 2014, 08:23:34 am ---Actually is Ms. 

Sandra

--- End quote ---

Awesome!

I hate that folks here are always assumed to be men.  I have four daughters who all show promise in being engineers of one type or another.
smgvbest:
I actually wanted to be a computer engineer specially designing CPU's but just could not pull of the finances so ended up going the electronics technician route right when they were a dine a dozen in Calif so ended up of all things a mainframe system programmer but have kept my electronics training alive as my hobby.  but still have allot to learn
Howardlong:

--- Quote from: msraya on December 16, 2014, 08:16:06 am ---My Hat's Off to You Mr Smgvbest!!  :clap:

I am afraid of break the sticker, but now I will go!!  :-DD
You makes the process look simple and self-explained.

Thank You!
Manuel

--- End quote ---

Manuel, if you follow Mike's instructions here http://youtu.be/KGcNS5g9ygg you won't break the sticker. The trick is to be patient, it might take five or ten minutes. I then also protect the loose end and its adhesive with some of the sticker backing paper and a little DIY paper envelope taped to the enclosure.
smgvbest:

--- Quote from: Howardlong on December 16, 2014, 02:46:32 pm ---
--- Quote from: msraya on December 16, 2014, 08:16:06 am ---My Hat's Off to You Mr Smgvbest!!  :clap:

I am afraid of break the sticker, but now I will go!!  :-DD
You makes the process look simple and self-explained.

Thank You!
Manuel

--- End quote ---

Manuel, if you follow Mike's instructions here http://youtu.be/KGcNS5g9ygg you won't break the sticker. The trick is to be patient, it might take five or ten minutes. I then also protect the loose end and its adhesive with some of the sticker backing paper and a little DIY paper envelope taped to the enclosure.

--- End quote ---

That's the one I followed and it works fine.   Thanks for posting the link
Patients is definitely the key to removing it intact.  It took me closer to 10 minutes to remove mine.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod