Products > Test Equipment

Sniffing the Rigol's internal I2C bus

<< < (748/899) > >>

msraya:
Oh! I'm sorry Sandra  :palm:

The rate of women/men EEngineering students at my University, here in Spain is very bad indeed.
So I suppose the wrong.

I will try to use the JTAG with my oscilloscope and will update when it succeeds.
Regards
Manuel

Rigby:

--- Quote from: smgvbest on December 16, 2014, 08:23:34 am ---Actually is Ms. 

Sandra

--- End quote ---

Awesome!

I hate that folks here are always assumed to be men.  I have four daughters who all show promise in being engineers of one type or another.

smgvbest:
I actually wanted to be a computer engineer specially designing CPU's but just could not pull of the finances so ended up going the electronics technician route right when they were a dine a dozen in Calif so ended up of all things a mainframe system programmer but have kept my electronics training alive as my hobby.  but still have allot to learn

Howardlong:

--- Quote from: msraya on December 16, 2014, 08:16:06 am ---My Hat's Off to You Mr Smgvbest!!  :clap:

I am afraid of break the sticker, but now I will go!!  :-DD
You makes the process look simple and self-explained.

Thank You!
Manuel

--- End quote ---

Manuel, if you follow Mike's instructions here http://youtu.be/KGcNS5g9ygg you won't break the sticker. The trick is to be patient, it might take five or ten minutes. I then also protect the loose end and its adhesive with some of the sticker backing paper and a little DIY paper envelope taped to the enclosure.

smgvbest:

--- Quote from: Howardlong on December 16, 2014, 02:46:32 pm ---
--- Quote from: msraya on December 16, 2014, 08:16:06 am ---My Hat's Off to You Mr Smgvbest!!  :clap:

I am afraid of break the sticker, but now I will go!!  :-DD
You makes the process look simple and self-explained.

Thank You!
Manuel

--- End quote ---

Manuel, if you follow Mike's instructions here http://youtu.be/KGcNS5g9ygg you won't break the sticker. The trick is to be patient, it might take five or ten minutes. I then also protect the loose end and its adhesive with some of the sticker backing paper and a little DIY paper envelope taped to the enclosure.

--- End quote ---

That's the one I followed and it works fine.   Thanks for posting the link
Patients is definitely the key to removing it intact.  It took me closer to 10 minutes to remove mine.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod