| Products > Test Equipment |
| Sniffing the Rigol's internal I2C bus |
| << < (783/899) > >> |
| pascal_sweden:
Some people wrote a few entries earlier in this forum post that DS1000Z and MSO1000Z series don't support SCPI commands to read out memory, and that this is the reason why you need to open up your scope and use JTAG to read out the memory. Apparently you don't need memory dump for DS1000Z series, as it will work with Riglol and serial number. But for MSO1000Z series you need memory dump, and there is where JTAG comes into picture, as SCPI does not work. Would be nice to really get this confirmed? I really hope SCPI works on both DS1000Z and MSO1000Z series. |
| pascal_sweden:
So this confirms that the Bildschirm tool does not work on DS1000Z and MSO1000Z scopes? |
| miguelvp:
--- Quote from: PeDre on May 29, 2015, 03:14:24 pm --- --- Quote from: pascal_sweden on May 29, 2015, 01:27:43 pm ---Would be nice to really get this confirmed? I really hope SCPI works on both DS1000Z and MSO1000Z series. --- End quote --- Here are the SCPI commands of the firmware 00.04.02.SP4 (DS1074Z-S). I have not found any commands for reading the memory. Peter --- End quote --- Strange no one looks for the programming manual: http://www.batronix.com/pdf/Rigol/ProgrammingGuide/MSO1000Z_DS1000Z_ProgrammingGuide_EN.pdf You are looking for WAVeform:DATA? (lowercase optional WAV:DATA? will work as well) but you need to set things up first Also there are ways to talk to the Rigol without the NI-VISA library. Same thing for the DS2000 but that one doesn't support telnet access but the DS/MSO1000Z series does. Programming manual for the DS2000 if your google fu is not strong enough http://www.tequipment.net/assets/1/26/Documents/Rigol/DS2072/ds2072_doc_5.pdf But if you mean the actual programming memory then no dice as far as I know. |
| ebastler:
--- Quote from: pascal_sweden on May 29, 2015, 03:25:28 pm ---So this confirms that the Bildschirm tool does not work on DS1000Z and MSO1000Z scopes? --- End quote --- You mean this tool? http://peter.dreisiebner.at/rigol-bildschirmkopie-lan/ Why would the SCPI command list imply that it does not work? On his web page, the author of the Bildschirmkopie software explicitly confirms that it works for the DS1000Z as well as the MSO1000Z, both via LAN and USB. |
| pascal_sweden:
So if I get it right: DS1000Z and MSO1000Z can be hacked through Bildschirmkopie tool after all, and there is no need to open up the scope and use JTAG. The people who open up their scope and use JTAG, just like to do it the hard way. |
| Navigation |
| Message Index |
| Next page |
| Previous page |