Products > Test Equipment

Sniffing the Rigol's internal I2C bus

<< < (838/899) > >>

psysc0rpi0n:

--- Quote from: qwertymodo on September 22, 2016, 07:15:56 am ---The guy I was referring to had the same model as me, MSO1074Z (not sure if his was -S or not), sorry I can't find the post. The DS1000 series doesn't require a memory dump, all you need is the serial number.

Sent from my m8wl using Tapatalk

--- End quote ---

Yeah, hope I can do the same for the MSO1104Z. I think the only guy that has the same model has me was McBryce but I think he used an earlier version of the firmware than the one I have!

McBryce:
Yup mine is an MSO1104Z-S and had a much older Firmware installed when I did the memory dump. I didn't have to worry about getting the timing correct.

McBryce.

psysc0rpi0n:

--- Quote from: McBryce on September 22, 2016, 09:30:40 am ---Yup mine is an MSO1104Z-S and had a much older Firmware installed when I did the memory dump. I didn't have to worry about getting the timing correct.

McBryce.

--- End quote ---

McBryce, these 2 models, MSO1104Z and MSO1104Z-S, are probably not the case that they are precisely the same, regarding hardware, but one of them has firmware limitation, right?

McBryce:
The "S" has an additional PCB as far as I can remember from Daves teardown. The Firmware is the same for all DSO1xxx and MSO1xxx as far as I know.

McBryce.

qwertymodo:
Correct, there is an additional hardware board inside the -S model for the signal generator DAC hardware, but they are running the same firmware.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod