Products > Test Equipment

Sniffing the Rigol's internal I2C bus

<< < (848/899) > >>

Edinson:
Peter, thank you for your support.

The connection is basically the same as mine. I had additionally connected the SRS: Scope 6 - Olimex 15.
I will change it according your setup and retry.

Edi

Edinson:
No change.
Still the Error with the EmbeddedICE version and I can't halt the CPU.

Edinson:
Finally I got it. It was probably a connection problem   |O
I did it exactly as shown in the picture of PeDre... and it worked. Thank you PeDre for sharing.

I halted when the logo disappeared and did the dump.
Then I generated the keys with the compiled windows version of rigup (post #4113). Thank you Neuro

And now I have an unlocked DS1074Z-Plus.

Edi

psysc0rpi0n:

--- Quote from: Edinson on October 16, 2016, 08:30:25 pm ---Finally I got it. It was probably a connection problem   |O
I did it exactly as shown in the picture of PeDre... and it worked. Thank you PeDre for sharing.

I halted when the logo disappeared and did the dump.
Then I generated the keys with the compiled windows version of rigup (post #4113). Thank you Neuro

And now I have an unlocked DS1074Z-Plus.

Edi

--- End quote ---

Nice one! Lucky guy! I didn't have such luck! My Rigol still's locked!

Daruosha:
I'm sure my question has been answered somewhere, but I cannot find it. My USB Blaster in JTAG mode has TCK,  TDO, TDI, TMS, Vcc and GND, But in the apparently the JTAG port on the scope has more pins like SRST and a few more? Anyone kind enough to help me with the wiring?

(I really need to read a bit about JTAG, stupid questions)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod