| Products > Test Equipment |
| Sniffing the Rigol's internal I2C bus |
| << < (861/899) > >> |
| loaderr:
2twingy: check if your keys start from 0's and do they have proper length (should be 8 or 16 hexadecimal digits), if not append 0 in front of key like 0x001234. Otherwise fixed Rigup should just work for you. |
| Twingy:
Hello loaderr, I've attached a copy of my output from rigup, do you see anything that looks out of the ordinary? Thanks. |
| Daruosha:
Since public and private keys are same across MSO-1000z models, is there anyway to calculate XXTEA and RC5 keys from serial number? I have the trial codes and looking for a solution to solve these keys from serial number and trial codes. Any suggestions? |
| jckz82:
I'm in the same situation as Twingy. - MSO1074Z bought in Dec 2016 - Software V04.03.SP2 - Board 2.1.4 - JTAG header absent from board - Ran memory dump immediately after logo disappears (did three dumps with the same results) - Used loaderr's fixed version of rigup Generated licenses are invalid. Any files or information I can upload that would help solve this? |
| Noize:
I had success upgrading my mso1074z-s 8) Software version 00.04.04 Board version 6.1.1 I compiled loaderr's version of rigup with VS 2013 Used a Chinese knockoff jtag dongle firmware: J-Link ARM V8 compiled 1 Dec 2009. Hardware version: V8.00 Turned on the oscilloscope then plugged j-link into the computer Started J-link commander from the command line>JLink.exe -speed 100 J-Link>connect ...... Device>arm9 ....... JTAGConf> (just press enter) J-Link>h (press enter when license screen appears) J-Link>speed 4600 J-Link>savebin mso1074z.bin 0x40000000 0x3FFFFFF J-Link>g Use Loaderr's file as per usual. I bought my scope from Rigol 3 months ago with the latest firmware installed, the jtag header was still present. Thank you to everyone who contributed :clap: I am now able to continue electronics thank god! Ha |
| Navigation |
| Message Index |
| Next page |
| Previous page |