Products > Test Equipment
Sniffing the Rigol's internal I2C bus
<< < (885/899) > >>
N2tl:
I don’t think the DS2000 (non-A version) has hardware support for 50-ohm termination, does it?
ted572:

--- Quote from: N2tl on July 17, 2019, 01:50:25 am ---I don’t think the DS2000 (non-A version) has hardware support for 50-ohm termination, does it?

--- End quote ---
You are correct, there isn't any 50 ohm termination capability in the DS2000 (non A).
JDubU:
Actually, there was a brief overlap in hardware versions between the DS2000 and DS2000A.  DS2000 started with hardware v1.xx but transitioned to hardware v2.xx just before the DS2000A was announced.  DS2000A only uses v2.xx hardware.  The relay controlled 50 ohm input terminator is implemented on hardware v2.xx but only the DS2000A allows it to be enabled from the front panel.  It can be enabled on a DS2000 (that has v2.xx hardware) only via SCPI command.
RetroDan™:
Successfully hacked my MSO1074Z-S.  If I upgrade the firmware to the most recent, will I lose my hacks?
McBryce:

--- Quote from: RetroDan™ on February 27, 2020, 03:06:28 am ---Successfully hacked my MSO1074Z-S.  If I upgrade the firmware to the most recent, will I lose my hacks?

--- End quote ---

I can't say 100% for the MSO1074Z-S, but for other devices including my MSO-1104-Z the hacks are still there after several FW updates.

McBryce.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod