Products > Test Equipment
SPD3303X-E another question regarding binding posts.
<< < (11/11)
daisizhou:
I did the same on CH2 channel, but CH2 is normal.
CH1 channel open or close always automatically offset 10-20mv
Electroplated:
A long awaited update about my faulty unit,

It was returned last week and the fault has been identified, I get a replacement unit tomorrow, invoice shows a different serial number :-)

One good thing to come from this is it promoted me to try every 4mm plug I had, there's at least 50 odd leads, I did find a few that where either worn or not up to the job so have ordered a load of new BUELA 20 K.

--

Electroplated:
A further update, the replacement psu arrived today, gave it a good going over and test, pleased to say there is sod all wrong with it, only tried the supplied leads and a few of my good ones, fit is as expected and all posts open fully.

Thanks to everyone who helped on this, was a bit of a bad experience but the helpful replies I have had nudged me on to swap it out.

Thanks again.

--
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod