Products > Test Equipment
Still Siglent SDG2042X over SDG1032X after new added features (TrueArb, etc)?
<< < (3/6) > >>
nctnico:
Be aware though that the SDG2042X has issues synchronising the output to an external 10MHz reference. On top of that, the type of issues seems to depend on the firmware version where Siglent fixed / broke stuff.
Roger Need:

--- Quote from: nctnico on May 30, 2022, 06:55:55 pm ---Be aware though that the SDG2042X has issues synchronising the output to an external 10MHz reference. On top of that, the type of issues seems to depend on the firmware version where Siglent fixed / broke stuff.

--- End quote ---

I am using the latest version of the firmware for the 2042X and have no problems synchronising to an external 10MHz reference.  What problem are you having?

Roger
bdunham7:

--- Quote from: Roger Need on May 30, 2022, 11:54:49 pm ---I am using the latest version of the firmware for the 2042X and have no problems synchronising to an external 10MHz reference.  What problem are you having?

--- End quote ---

From an earlier discussion:

https://www.eevblog.com/forum/testgear/keysight-vs-tek-function-generators/msg3878804/#msg3878804
hpw:
currently discussing again about the square wave FM fade out

a) as last involved Siglent Support engineer left... as too small FPGA memory .. then promised a FW only to provide within on channel

b) from new engineer... quick answer: not possible to fix

c) same as SDG2K as SDM6K...

d) just go figure as looks as a diy company

so decisions are made about face looser lands
hpw:

Setup:
 
•   Square wave 10Mhz
•   FM modulation 500Hz
•   Low FM deviation value 1Hz or lower, may also on 2Hz
 
Issue:
 
•   Modulation fades out after a while, use SSA3K to validate
 
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod