Products > Test Equipment
Suitable USB-C powerbank for Rigol DHO800/900 series
<< < (3/3)
DaneLaw:

--- Quote from: Pinkus on February 08, 2024, 11:33:08 am ---Note for the post above: Search at Aliexpress for "ripple test board". The set (USB A und USB C) costs about $30.

--- End quote ---
Doesn't do much at my end, ..https://aliexpress.com/w/wholesale-ripple-test-board.html?spm=a2g0o.productlist.search.0
but then again quite a lot of listings are behind-region lock in 2024 on Aliexpress, so could be that you see listings I dont, not to mention these adapters are quite old, so you can't take for granted they are still for sale.
Maybe you could share an active purchase link, as I cant.. hence none in stock for quite a while.

In regards to powerbanks and certain Rigol products, worth noting they seem to consume a roundtrip to the moon & back in their breathing standby-mode atleast on this unit I got, that aint a DHxxx but a signal gen [DG800PRO) that uses the same form-factor, but it's a new product not released yet in the west, so could also be down to a far from optimal firmware.

above 6 watts in a closed with power-status  (FY6900 around 0.4w & DG800PRO 6watt)
https://i.imgur.com/wtk7uhu.mp4
Houseman:
Is it a BNC connector connected to the VUSB and ground via a resistor and a capacitor?
How do you use it?
Thank you
flaotte:
I just want to double check.
If oscilloscope is powered from power bank, is it save to measure mains/mains coupled wires?
300V insulation means single phase at a time?
ebastler:

--- Quote from: flaotte on March 11, 2024, 10:17:57 am ---I just want to double check.
If oscilloscope is powered from power bank, is it save to measure mains/mains coupled wires?
300V insulation means single phase at a time?

--- End quote ---

You run less danger of damaging the scope that way -- since it is not grounded, you will not cause a short circuit if you connect the probe's ground clip to a high potential.

But you much increase the danger of damaging yourself! While you will not notice a problem with the scope's functionality if you make that connection, it will connect parts of the scope which you can touch -- nost notably the BNC connectors, and the shells of any BNC plugs you connect to them -- to that high potential. You can potentially kill yourself by tuoching them.

So, please don't use the scope to measure mains voltage that way!
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod