Products > Test Equipment

T7 Tester

<< < (5/8) > >>

slybunda:
Yep this looks like a simple device on the inside, could probably build one on a breadboard for little cost.

What sort of tests should i do on my one to see if its lacking any functionality?

madires:
The functionality of the tester clones with a modified firmware is limited anyway (compared to the original OSHW firmwares). For the fancy display output they have to drop features because of the small flash size.

slybunda:

--- Quote from: Serg65536 on January 13, 2024, 01:40:55 pm ---As far as I know, it's possible to swap the chip to atmega328 with minor changes and enjoy the fool glory of the original open source tester.
But that's not a trivial task.

--- End quote ---

you know, now thinking about this that atmega328 chip im sure i have that on an arduino uno r3 i have lying around somewhere. maybe that can be adapted to do the job?

NF6X:
I just got an "AITRIP" brand T7 tester from Amazon. Mine has an APT32F172K8T6 microcontroller. You know you're getting the good stuff when they use a genuine TFXTDOL brand ZIF socket.  ::)

NF6X:
When I short 1-2-3 to enter the self-test mode, it identifies itself as "FNIRSI-TC1". It does not display a version number at the end of the test.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod