Products > Test Equipment
t7 tester
(1/1)
p.larner:
i have a t7 component tester,its had little use but now when i press the yellow button without anything connected  it reads as two diodes,one on pins 1+2 and one on pin 1+3 both with a vf of 1.098v,is it busted or is that normal,as is it still tests caps ok.
siealex:
Check the protection diode set (a small 6-pin chip connected to the inputs). One of its diodes may be shorted.
p.larner:
would you have a pic ?
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod