Products > Test Equipment
TC1 lcr-meter transistor-tester fix
<< < (46/80) > >>
Glide:
My one is showing just zener diode now, I found out that D2 is dead. Can you please tell me the value for D2.
madires:
If D2 is related to the boost converter for the Zener test voltage then it should be an SS18. Any jellybean Schottky diode rated for >=80V is fine.
Glide:
Thank you, I  have around a BAS86 but is rated just for 50V. You think I can use it?
madires:
It depends mainly on the output voltage of the boost converter and the type of converter. There are several models of the TC-1 (and family) with Zener test voltages ranging from about 25V up to 45V. For a model with a lower output voltage a 50V Schottky could be ok.
Glide:
I think is busted, now is showing 330pF 1-3 without nothing connected.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod