Products > Test Equipment

TC1 lcr-meter transistor-tester fix

<< < (8/80) > >>

madires:
There's a Russian forum: https://vrtp.ru/index.php?showtopic=16451.

Del:
What and in what file should be corrected to freeze occur only once, after pressing the button ? And then the tester should be turned off . And at me the screen is displaced on nekkolko pixels up and to the left, that is it is necessary to shift it down and to the right - as it to consult.

madires:
You can use LCD_OFFSET_X and LCD_OFFSET_Y to adjust the display's offset. What do you mean by "freeze"?

Del:

--- Quote from: madires on December 28, 2019, 04:12:14 pm ---You can use LCD_OFFSET_X and LCD_OFFSET_Y to adjust the display's offset. What do you mean by "freeze"?

--- End quote ---
Sorry, I'm using a translator |O  . freezing is wrong , I meant a single measurement . insert the component into the pad, press the button, see the readings and after 10-20 seconds the device will turn off itself .



LCD_OFFSET_X and LCD_OFFSET_Y to adjust the display's offset -      this in what file to edit ?  :-\

madires:
LCD_OFFSET_X and LCD_OFFSET_Y  are set in the display section in config_644.h (ATmega 324/644/1284). For a single measurement you would have to modify main() since there's no setting for that.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod