Products > Test Equipment

TC1 lcr-meter transistor-tester fix

<< < (78/80) > >>

tedris:
Can you send a picture? How did you do this, what did it look like? I bought 3 atmega324pa chips thinking that the legs would be short again. However, both programming it and finding the software is a serious problem. There is no software for T7, it will not return to its original state, I have no idea if other versions will work.

Kim Christensen:
Sorry, I've already disassembled the breadboard and didn't take any pictures at the time. But it wouldn't have been much to see anyway. I simply built the programmer on the breadboard and connected it to my TC1 via grabber clips. A very temporary setup. I complied the binaries using WinAVR.

tedris:
Hello, I couldn't find how to make program settings and how to make upload settings. I connect to Atmega and it uploads but a white screen appears, I think there is a special setting that I need to choose.

madires:
You can ignore that when using a quartz crystal. That 'oscillator calibration byte' is an adjustment value for the internal RC oscillator.

tedris:
https://github.com/Ho-Ro/ComponentTester
I think I need to edit and compile the file here with ready-made settings according to my own device. Is there a similar video about this? I don't understand how to do it. Is there a chance to compile in Atmel studio? I'm using Windows 10.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod