Products > Test Equipment

TDS 540 problem

<< < (5/5)

vaualbus:
 I've just finish to check the voltage and if I take correctlly, all the voltage are zero!!
Securly a psu failure.
Any idea in what could be the problem? Bad capicitors? bad transistors?
There are  Any others common failure of this psu a part of the capicitors?
Thanks for the helps.
Best regards, Alberto Vaudagna.

vaualbus:
So just find some component blow on psu. VR4 and VR5 seem overheated, Q9 is sorted and a 200ohm resistor read about 100ohm (low consider the resistor is 5%).
I wish it could solve the problem.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version