| Products > Test Equipment |
| TDS3000 Dallas RTC RAM Init |
| << < (6/6) |
| Miti:
Can you erase this device? I tried to erase it but it still has some garbage left. |
| Miti:
Ok, I don't know what was missing or at what location but it is not only the MAC address that's needed to connect over the Ethernet. It only started working again after I loaded the bin attached in the link below. I modified the MAC and the hours of operation and it is good now. https://www.eevblog.com/forum/testgear/tek-tds3000-series-and-dallas-nvram/ |
| rauldm:
Very nice, you remove the chip from scope? |
| Miti:
--- Quote from: rauldm on May 20, 2023, 05:09:46 am ---Very nice, you remove the chip from scope? --- End quote --- Yes, I have and I installed a socket. |
| Navigation |
| Message Index |
| Previous page |