Products > Test Equipment

TDS3000 Dallas RTC RAM Init

<< < (6/6)

Miti:
Can you erase this device? I tried to erase it but it still has some garbage left.

Miti:
Ok, I don't know what was missing or at what location but it is not only the MAC address that's needed to connect over the Ethernet. It only started working again after I loaded the bin attached in the link below. I modified the MAC and the hours of operation and it is good now.

https://www.eevblog.com/forum/testgear/tek-tds3000-series-and-dallas-nvram/

rauldm:
Very nice, you remove the chip from scope?

Miti:

--- Quote from: rauldm on May 20, 2023, 05:09:46 am ---Very nice, you remove the chip from scope?

--- End quote ---

Yes, I have and I installed a socket.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod