Products > Test Equipment
Teardown - Hitachi V1065
<< < (8/18) > >>
mlloyd1:
Robert:

Thanks so much for your VERY informative investigation.
 :-+
My V-665 has this exact problem and I'd like to repair it so my grandson can have this scope when he is ready for one.

However, I think the exact OEM replacement is actually the Fujisoku ALE2G-2M4-10-Z, right? Looks like the  ALE2S-2M4-10-Z is a rocker.

mlloyd1
rbm:
Hi,

Either model can be equipped with a toggle or rocker actuator.  The difference between the G and S models is that the G has 2.54mm between contact rows and the S has 5.08mm between contact rows.  The S is the correct original designation.
old gregg:
Hi,

I'd like to change the push/pull in my hitachi VC6023, they're all dirty and the switching isn't done properly anymore (the trigger becomes quite tricky). The service manual gives as references EVH - YK3325B14 (10K push pull). Does anyone know where I can find a replacement or a sibstitute ? (It's annoying to not being able to use the X10 mag)

I googled the refrences with no success.
Ether:
Hi, is it possible to repeat the frequency mod on a V-1560. Also, is there some way of preserving the holdoff function while getting the frequency counter?
grumpydoc:

--- Quote ---Hi, is it possible to repeat the frequency mod on a V-1560.
--- End quote ---
Probably - have a look at your CPU board and see if the jumpers correspond to the "no frequency counter" setting. If so swap them.


--- Quote ---Also, is there some way of preserving the holdoff function while getting the frequency counter?
--- End quote ---
Not sure what you mean by preserve?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod