Products > Test Equipment

Teardown - Hitachi V1065

<< < (8/18) > >>

mlloyd1:
Robert:

Thanks so much for your VERY informative investigation.
 :-+
My V-665 has this exact problem and I'd like to repair it so my grandson can have this scope when he is ready for one.

However, I think the exact OEM replacement is actually the Fujisoku ALE2G-2M4-10-Z, right? Looks like the  ALE2S-2M4-10-Z is a rocker.

mlloyd1

rbm:
Hi,

Either model can be equipped with a toggle or rocker actuator.  The difference between the G and S models is that the G has 2.54mm between contact rows and the S has 5.08mm between contact rows.  The S is the correct original designation.

old gregg:
Hi,

I'd like to change the push/pull in my hitachi VC6023, they're all dirty and the switching isn't done properly anymore (the trigger becomes quite tricky). The service manual gives as references EVH - YK3325B14 (10K push pull). Does anyone know where I can find a replacement or a sibstitute ? (It's annoying to not being able to use the X10 mag)

I googled the refrences with no success.

Ether:
Hi, is it possible to repeat the frequency mod on a V-1560. Also, is there some way of preserving the holdoff function while getting the frequency counter?

grumpydoc:

--- Quote ---Hi, is it possible to repeat the frequency mod on a V-1560.
--- End quote ---
Probably - have a look at your CPU board and see if the jumpers correspond to the "no frequency counter" setting. If so swap them.


--- Quote ---Also, is there some way of preserving the holdoff function while getting the frequency counter?
--- End quote ---
Not sure what you mean by preserve?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod