Products > Test Equipment
Teardown - Hitachi V1065
<< < (9/18) > >>
Ether:
Thanks for the reply.


--- Quote ---IT WORKED! I now have a frequency counter on the 1065 non-A. It's the 4th option of the cursor mode. Since you have a non-A, I will describe where it is:
--- End quote ---

I was referring to true's post that the frequency counter was the fourth option of the cursor selection and AFAIK, that's to adjust the holdoff.
grumpydoc:

--- Quote ---I was referring to true's post that the frequency counter was the fourth option of the cursor selection and AFAIK, that's to adjust the holdoff.
--- End quote ---
Ah, see what you mean.

Holdoff isn't affected - the frequency counter is the 4th measurement function - keep on pressing the selector down until you get there
Ether:
I replaced the zero ohm resistor as according to true's post but I'm not getting the frequency counter. I did try pushing the selector all the way down though so any help would be very appreciated.  ???
true:
Did you keep going down? If it doesn't work, maybe there is something else different in the 1565. I don't know. Would need to look at schematic again, and I'd be willing to, but after some serious recent trouble I am in no mindset to be able to.
Ether:
Thanks for the reply. I did tried holding the switch down and I compared the 1060 board with the 1560. They match perfectly. Is it possible for you to check my picture against what you did and see if I screwed up the positioning? I fixed the solder joint after the picture  was taken so soldering should be fine. Also, pictures of your 1060 with the counter enabled would be nice.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod