Products > Test Equipment
Teardown - Hitachi V1065
Ether:
Thanks for the reply.
--- Quote ---IT WORKED! I now have a frequency counter on the 1065 non-A. It's the 4th option of the cursor mode. Since you have a non-A, I will describe where it is:
--- End quote ---
I was referring to true's post that the frequency counter was the fourth option of the cursor selection and AFAIK, that's to adjust the holdoff.
grumpydoc:
--- Quote ---I was referring to true's post that the frequency counter was the fourth option of the cursor selection and AFAIK, that's to adjust the holdoff.
--- End quote ---
Ah, see what you mean.
Holdoff isn't affected - the frequency counter is the 4th measurement function - keep on pressing the selector down until you get there
Ether:
I replaced the zero ohm resistor as according to true's post but I'm not getting the frequency counter. I did try pushing the selector all the way down though so any help would be very appreciated. ???
true:
Did you keep going down? If it doesn't work, maybe there is something else different in the 1565. I don't know. Would need to look at schematic again, and I'd be willing to, but after some serious recent trouble I am in no mindset to be able to.
Ether:
Thanks for the reply. I did tried holding the switch down and I compared the 1060 board with the 1560. They match perfectly. Is it possible for you to check my picture against what you did and see if I screwed up the positioning? I fixed the solder joint after the picture was taken so soldering should be fine. Also, pictures of your 1060 with the counter enabled would be nice.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version