EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: L_Euler on January 08, 2019, 01:39:58 pm

Title: Tek 2440, 2430 Cursors
Post by: L_Euler on January 08, 2019, 01:39:58 pm

New here,

Other than turning down the intensity, how do you turn off the measurement cursors on a Tek 2430 or 2440?  I don't see it mentioned anywhere in the user or service manual.  Occasionally I see them turn off, but can't decipher the path.

Title: Re: Tek 2440, 2430 Cursors
Post by: particleman on January 08, 2019, 02:09:59 pm

Just press the front button. If volts is underlined press the volts button.

Title: Re: Tek 2440, 2430 Cursors
Post by: 0culus on January 08, 2019, 08:58:46 pm

If it has a "setup" button like my 2465B, running that routine also turns off any active cursors. Otherwise, if you are using delta V for example, simply press it once to turn the cursors on and again to turn them off.

Title: Re: Tek 2440, 2430 Cursors
Post by: L_Euler on January 09, 2019, 12:59:19 am

I am sooooooo stupid.  I though I tried push the active mode button, but I guess not.  Yep, turns them off.