Products > Test Equipment
Tek 2465 Horizontal Sweep Issue
(1/5) > >>
kellymcdonald78:
I'm not sure if what I'm seeing is the hybrid chip failure or not, but for the life of me I can't seem to get a horizontal sweep (entirely possible this is user error). Everything else seems to work, I get a dot on screen, display works fine, I can adjust manually horizontally and vertically and the cursors (both T and V) work. I haven't used this scope in a decade and wanted to rule anything obvious out before I start tearing it apart. I followed the manual details to get a baseline, but no scan

Thanks
tautech:
Welcome to the forum.

Check it is not set to XY mode.
kellymcdonald78:
I don't think so. I've got the Sec/Div switch set to 100ms locked
bdunham7:

--- Quote from: kellymcdonald78 on April 19, 2024, 01:17:51 am ---I'm not sure if what I'm seeing is the hybrid chip failure or not, but for the life of me I can't seem to get a horizontal sweep (entirely possible this is user error). Everything else seems to work, I get a dot on screen, display works fine, I can adjust manually horizontally and vertically and the cursors (both T and V) work. I haven't used this scope in a decade and wanted to rule anything obvious out before I start tearing it apart. I followed the manual details to get a baseline, but no scan

--- End quote ---

Can you post a clear photo of the front of the scope as this happens?  We should be able to spot any user errors that way.
kellymcdonald78:
Here you go. I also ran the self test and it comes back clean
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod