Products > Test Equipment

Tek TDS3000 pacmanBuildView

<< < (5/5)

analogRF:

--- Quote from: darkstar49 on October 06, 2020, 10:03:06 am ---on the other hand, if it's for your own use, who cares ? You can either leave it in DEV mode forever, or just ignore that you'll have the counters wiped...
And in most of these good old boys, the NVRAM should be replaced anyway, time for a backup before playing around. ;-

--- End quote ---

true. even if you sell it, shouldn't be a problem (I did ;D ) and there are couple of sellers on ebay selling these that show very low number of power ons and low hours

the operating hours can be easily restored, unfortunately nobody seems to know how to restore the number of power ups. Seemingly it is not stored in the NVRAM

DC_to_Light:
How to enter and exit Devel mode.

On my TDS3064B , I exited Devel mode by the following:

Utility->Config->Tek Secure Erase Memory
Utility->Diags->Error Log    still shows power ups, and operating hours.

Activating  Devel mode is by holding SELECT while turning on power, until traces are shown.
   POST screen is not seen.

I did not see the pacmanBuildView display, maybe because my scope has B at end of part number

JusTideaFIX:
To exit Devel (Development) mode try holding in the "B-TRIG" button while Scope power-up from power down state. That forces a system RESET.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod