Products > Test Equipment

Tektronix THS7xxx Scope Hack/Teardown/Discussion - FW 1.16 found

<< < (78/95) > >>

walter.aranda:
Hello, in my case I also have the same problem, is a function generator necessary to correct this offset? or with a DC source enough?

walter.aranda:
Hello, I will not find the Metratek software available for download, could you please provide it?
About the display screen: Probably a change of polarizers is necessary, the procedure is simple (although time consuming)

walter.aranda:
Hi, how long does it work with those two 18650 batteries?

little_grey:
Using the lithium cells will need the internal charger to be changed as currently its only nmhi at the moment.

walter.aranda:
It's not broken my friend, it's only the glue from the polarizers, you can remove them and carefully clean the screen with thinner (it took me about 3 hours of careful cleaning), then buy two 11.4 x 8 cm self-adhesive polarizers, both can be 90 or 0 degrees. Then, before peeling them to the screen, verify that the orientation is correct.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod