Products > Test Equipment
Tektronix THS7xxx Scope Hack/Teardown/Discussion - FW 1.16 found
walter.aranda:
Hello, thank you for your input. I have been doing some tests here and I noticed that the post-processing options are not working in the program. What could be causing this?
jal1234:
I am having a similar issue. I've installed THS7xx.exe and SignalAnalysis apps. I can get a hard copy, either single or continuous. But when I press Ch1 under SignalAnalyzer, I either get "The selected channel is not activated" when it is, or "The values of the scope display could not be read out.", or both. HardCopy shows my THS720A as connected. I'm on firmware version 1.11 for the 720A, HardCopy v1.3, and SignalAnalyser v4.0. I'm at the 38,400 baud, using the Tektronix serial cable, direct to a serial port on my CF-19 laptop.
Any ideas?
Jon
walter.aranda:
Yes, I have not yet been able to solve this problem with the error in post processing, at the moment I am using Wavestar (official Tektronix software), it is a good idea since Tek released the use licenses. It's good, the only bad thing I think is that sometimes it hangs and doesn't let me reopen it and I have to restart the PC.
jal1234:
I also found SignalAnalysis v4.2, but the same issue.
Where did you find the Wavestar software and license info?
Jon
harrimansat:
I had the same problem, until I fount out that if you close in process manager some 32 bits process, I don“t remember the name, you can restart wavestar.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version