Products > Test Equipment
Tektronix THS7xxx Scope Hack/Teardown/Discussion - FW 1.16 found
jal1234:
It tries to connect, fails, and errors out. This is after I've verified the basic Hard Copy program works ok. Are you using 9600 or 34800 baud?
Jon
mrprecision:
Which tool can not connect? Can you connect with THS7XX HardCopy and the the the scope display via remote? Can you set the scope to factory defaults and only change in the scope to 34800. The tool works only with 34800 and default settings.
TERRA Operative:
Have you set the port on the PC to the same baud rate?
I'll have to experiment, but I seem to remember having to set that in Windows, maybe...
jal1234:
--- Quote from: jal1234 on September 02, 2024, 11:31:56 pm ---It tries to connect, fails, and errors out. This is after I've verified the basic Hard Copy program works ok. Are you using 9600 or 34800 baud?
Jon
--- End quote ---
Hard Copy connects fine at 34800, and displays the screen. It can also do the quasi real time updates on screen. When I try to use the add on, then it won't connect.
Jon
jal1234:
Update. Not sure what I did different, but after erroring out once, now Signal Analyzer connects. When it eventually opens, now I get this screen, sorry it's at 90°. When I click OK, I get just a blank screen.
Jon
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version