Products > Test Equipment
Tektronix 576 Curve Tracer Adapters
<< < (8/9) > >>
CatalinaWOW:
That looks really elegant.  Only problem is that everyone will want one.
NF6X:
Thank you! I think it will outlast the plastic one. :)

I considered just 3D printing a replacement, but the side walls of the mounting cup are pretty thin. I think the layers might separate under mounting tension. Then I considered turning one out of delrin... and then I remembered that lovely brass round bar I had left over from another project.
David Aurora:

--- Quote from: NF6X on February 07, 2023, 06:22:40 am ---Thank you! I'll take a look at the cover.

I made a replacement for the broken plastic mounting cup out of brass, and I also made a spanner socket for the Kilo counting knob nut out of some 1144 steel. I had to get creative with the mounting cup dimensions, since I didn't have enough of the plastic cup left to measure all of its details. I am happy with how it turned out.

--- End quote ---

Oh snap! That looks killer!
SoundTech-LG:
So did you get it all fixed up???  I spent some time gluing in the CUP tonight with JB Weld.
https://www.eevblog.com/forum/testgear/type-576-an-interesting-day/new/#new
SoundTech-LG:
That brass cup redesign is a real Beauty!!! I want one!  But I already JB Welded the plastic one in there  :-[
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod