Products > Test Equipment
Tektronix 7844 traces fade with scan speed
(1/1)
Gianni:
Hi,
I have a 7844 oscilloscope that has two problems:
1) traces fade with scan speed, until they are no longer visible at 50ns/div; if I raise the intensity, I only lose the focus. The problem is exactly the same on both beams.
2) the readout "dances". I have already tried changing the whole board with another that is certainly good, but nothing changed. All voltages seems to be right and clean.
I have a video but I am not able to upload it (which format should I use?)

Unfortunately I have not a high voltage probe, but in 7844 I do not find a test point for it however.

Can anyone please give me some direction where to investigate?

Thanks
perdrix:
Which timebase are you using?  What frequency is the signal - if you're using a 1kHz signal you should not expect to be able to see it at 50nS/div
 - think about it for a while and you should be able to work out why.

D.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod