Products > Test Equipment

Tektronix New 3/4-Series Scope (June 4th!)

<< < (15/26) > >>

JPortici:
No isolated channels, huh :(? (six channels is cool, though)

EEVblog:
So no more 2 channel model? Makes sense.
The price for the 1.5GHz is going to go sky high.
Will be intyeresting to see if all models are 1.5GHz, or they have two different front ends to get the cost down.

David Hess:

--- Quote from: EEVblog on May 13, 2019, 03:39:55 pm ---So no more 2 channel model? Makes sense.
--- End quote ---

It especially makes sense because if triggering is done digitally, then an entire digitizer has to be included for the external trigger input anyway and if the vertical signal conditioning uses an integrated solution, it makes little sense to have special version for a trigger input.  At that point, all of the hardware for a complete vertical input is included anyway so it might as well be a full vertical input.  I am only surprised that this never led to three channel DSOs.

Bud:
So guessing from the nomenclature, the scopes are bandwidth software upgradeable. Will keep some folks on this forum busy  >:D

LapTop006:
I wonder if it's 6analog + 16digital or the same as the 5 series.

I was hoping for 8, so far the only way I've run out of channels on my HPAK has been rail monitoring and even my simple board has more than six rails.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod