Products > Test Equipment
Tektronix P5205 vs MICSIG DP20003
(1/1)
rauldm:
I put my active probes with 10 Vpp sinusoidal signal with sweep rate of 500 ms from 1 MHz to 100 MHz with siglent sdg 2042X, you can observe linearity on channel 1 from Tektronix probe and you can see how micsig can't give 100 MHz specified in its datasheet. I did that because my Fluke 199c is 200 MHz oscilloscope starts to attenuating from since 60 MHz, I wanted to know how good the response of the probes was as a function of frequency, it is clear that it is not a bode plot, but it gives me an idea of how reliable it could be to take measurements with the micsig probe in that frequency range.
Regards
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod